Robertshaw Electronic Furnace Control Board 695-003
Replace the following part numbers
Rheem & Rudd
47-22827-01, 47-22827-81, 47-22827-82, 47-22828-01, 47-22828-02
47-2282701, 47-2282781, 47-2282782, 47-2282801, 47-2282802
472282701, 472282781, 472282782, 472282801, 472282802
The Robertshaw 695 Series electronic blower motor controls were designed for use on heating and cooling equipment. The 695 controls the operation of the induced draft blower and the circulating blower in all thermostat modes. On a call for heat, the induced draft blower is energized. A pressure switch then proves the induction blower is functioning and brings in the gas valve. Operation of the gas valve starts the "on" delay timing. At the end of a pre-selected (and fixed) delay, the circulating blower is energized and it runs continuously until the call for heat is satisfied. At this time, the "off" delay (adjustable) is initiated and the circulation blower operates until the "off" delay times out.
Input voltage: 115 VAC, 60 Hz
Control voltage: 18-30 VAC
Inducer current: 2.5 FLA, 3.5 LRA @ 110/120 VAC, 1.5 FLA, 1.75 LRA @ 220/240 VAC
Blower current: 11.0 FLA, 24.5 LRA @ 110/120 VAC, 11.0 FLA, 24.5 LRA @ 220/240 VAC
Ambient temperature rating: –40 to 176°F
Humidity: 95% non-condensing